Cement Based Full Elastic Full Flex 2k

Used in wet areas such as terraces, balconies, bathrooms; under ceramic tiles; on horizontal and vertical surfaces.

A cement-based, liquid-applied waterproofing product with crack-bridging ability at normal temperatures. Complies with TS EN 14891 standard. Provides a seamless waterproofing layer on the surface. Fully elastic structure with high adhesion strength. Easy to apply.
Tariff No: 15.270.1005 Waterproofing done in two layers using cement-based, polymer-modified, two-component ready-to-use mortar.

The surface to be applied must be clean, dry, and free from materials such as oil, dirt, or anything that could prevent adhesion. Raw concrete and plastered surfaces should be lightly moistened with water before application and waited until no water puddles remain but surface stays damp. Deep cracks and voids should be repaired with cement-based repair mortars.

Use only the designated liquid (Component B) for mixing; no other products should be added.
After a minimum of 24 hours post-application, ceramic tiling can begin.
The applied area must be protected from sunlight, frost, and rain for 3 days.
The application surface temperature should be between 5 – 35 °C.

For each coat, slowly add 10 kg of Component B to 20 kg of Component A and mix with a mixer for about 3 minutes. After resting the mixture for 3 minutes, mix again.
The prepared mixture should be applied to the surface with a brush or trowel in at least 2 coats, with layers applied in opposite directions for better coverage. The pot life is approximately 45 minutes. The waiting time between coats at 20°C is about 4 hours. In high-build or flexible areas, reinforcement such as fabric or fiberglass mesh can be embedded between layers to strengthen the application.

CONSUMPTION: Approximately 1 kg per coat. Minimum 2 coats required.
STORAGE CONDITIONS: Store unopened in original packaging in a cool, dry place.
SHELF LIFE: 1 year from production date.